You can use a funnel to make sure all of the baking soda goes.

How to fix the drain plug in a bathroom sink. This rod is often attached. Doing a bit of extra maintenance. In this diy video, i will show you how to fix stuck stopper in the bathroom sink faucet.

The lever or lift knob is on or near the faucet body and connects to a lift rod. There are a few things you can do to check if there is a local blockage: Remove and clean the trap (there are.

Kung fu maintenance demonstrates a variety of ways to repair bathroom sink pop up drains.to have someone like me make repairs for you click the following lin. I will remove all the assembly drain plug, pivot rod, horizontal. Replace everything in its original location.

Run boiling water down the sink. Before replacing the stopper, you should take the opportunity to pull any hair and gunk out of the hole. Now, verify that you have a good seal.

With the plug out of the drain opening, you can repair or replace the drain plug spring and get your bathroom sink drain operating. Put the drain stopper into place. Then, tighten the clevis screw.

Lift up on the sink stopper to pull it out of the drain, taking care to avoid damaging the stopper. Drop the new drain plug into the hole in the finished flange from the top of the sink. Remove hair with the hair remover.