Soldering or using solderless connectors.

Connecting led strip lights together. Clipping and using cable with connector to connect led strip lights way 3: Rub a few times on the sponge that is full of water. Clipping and using connectors to connect led strip lights way 2:

This process will permanently keep your led strip light connected for a long time. What kind of circuit should be used? A general rule is not to connect more than three complete strips end to end without adding in extra, higher gauge power wire or additional power supply units down the line.

Keep the tip of the soldering iron clean. Correctly connecting the positive and negative terminal to the solderless connector will ensure the success of the installation. These wire connectors also help to connect two light strips together as well as allow the led strip to curve in different shapes as well as fit in profile areas.

5 steps to soldering led strip lights： step 1. You will need to connect the female end of each strip or run. Soldering is very reliable, but it takes a lot of time if you have many different.

Slide the connector across one of your led tape lengths to make sure the metal pieces inside the clamp are in clear contact with the solder on the led tape, avoiding the. As long as the voltage and current used by each lamp strip are the same, they can be used together. There are two ways to connect the strips together:

Different color light strips can be used together. This method entails constructing separate runs of led strip sections, each of which is directly. Another way of connecting multiple led strip lights is by using a soldering iron.