Custom built transoms can be added to tubes for 700 for up to 120 hp motors or 800 for.

Pontoon log sealer. If you do not have any coatings at all on the bottom of the boat we suggest to sand the pontoons with 80 grit and then apply Tuff Stuff High Build Epoxy. An electric power sanderbuffer and five buffing pads. USED U-Shaped 23W x 25H Pontoon Tubes in Stock.

If any Protectant is on the boat you will see it dissolve. 1989 Bayliner Capri 35 Hp Johnson 4 Blade 14 4 Blade Pair 460 Marine Engine 496 Marine 70 Hp Johnson Seal Aerator Valve Afi Boat Horn Alumacraft Anchor Lift Bilge Blower Used Blue Sea Marine Blue Sea Relay Boat Bimini Top 8 Boat Chair Boat Engine 5hp Boat Fender Clips Boat. M² slow punch sealer is all about seal punch.

Thus preventing excessive end checking of timber particularly while stacked at sawmills. It works best when used with our race proven and fisherman approved bottom coat VS721. This creamy semi-thick paint forms a sealing blanket over the worn aluminum.

9500 a sheet at my supplier is case anyone is interested. So the boat will be covered. Floating Aluminium Pontoon Boat Log Tubes 18 Foot x 25 Inch Diameter for sale.

Drill a hole through the cork the same size as the vinyl tubing and pull the tubing about 7 inches through the cork. Seal each side of the cork where the tube protrudes with water-resistant silicone sealant. FACTORY NEW u-shaped transom pods for mounting behind u-tubes to make center transom tube combinations UP TO 300 HP motors are available for bolt-on applications for 1000.

Apply a coat of epoxy sealer over the area with a. 15ft to 33ft Custom Marine Aluminum Pontoon Floats Pontoon Log Tubes for pontoon boat for Replacement. End Sealer is an off-white fluid emulsion of waxes and water designed to prevent end checks or splits in cut or sawn timber.