Put your back foot in the back binding and then tighten the ankle and toe straps firmly.

How to put bindings on a snowboard. Position the bindings on the board (more details for the right positioning here). What you’ll need to set up your snowboard bindings. Also make sure not to make the stance to narrow when riding.

For a disc system, align the 3 or 4 disc holes (depending on the fixing system and the discs supplied). Adjust the toe ramp to the appropriate length using the boot as a guide. Next, find which end of the snowboard is the tail and which is the nose.

When purchasing your binding, know that most come with several different base plates to ensure. Note there are numbers on the disk. How to set up snowboard bindings in 7 steps.

Each notch is usually three degrees. Hold the binding and push the disk up from below with your fingers. The following article will guide you through the process of installing bindings in a way that should work with most setups.

Rotate the disk until the your chosen angle faces. The stance of your legs should be. How to install snowboard bindings choosing the proper binding.

Did you just buy a new snowboard or are you struggling to find the right board/binding setup? Feel free to change the angle and experiment when riding. Insert the screws and washers into all four holes on each binding and tighten down until your bindings are secure.