The garage door opener’s light serves as a programming indicator, so make sure it is in functioning order.

Clicker garage door opener keypad programming. Genie garage door opener remote and keypad programming instructions. This will activate the garage door opener and programming is complete. Be sure to clear the garage door area of any obstructions.

The light will blink green to indicate that it is in programming mode. To reset your clicker garage door keypad, you need to find the learn button. Once you’ve found the learn button, press and hold it for about 10 seconds.

Clicker keypad programto smart learn on type4 you. Id dip switch type • 11 = dip. Access the motor unit, normally located above the garage door opener using a ladder.

Before you begin programming, make sure to have the following: Press and hold the program button for approximately 2 seconds until the led lights turn on. On the clicker keypad, press and release 0 again.

Linear garage door openers with: Locate the learn button on the. Your 4 digit pin number you want.

Locate the learn button on the motor unit, usually on the backside. Program clicker garage door keypad press down on the learn button on your garage door opener once more. On the clicker keypad, enter the pin from step 1, and press and release the 0 key.