Want to say thanks for the video?

Whirlpool water heater pilot light. A bad thermocouple will shut off gas to both the pilot and the burner so the pilot light won’t stay lit. First, cut off the gas supply, switch off your heater, and wait for the thermocouple to cool off. There will be a red or black button marked “ignition,” press it for about 60 seconds.

Whirlpool water heater pilot not lighting i discovered this morning that the pilot light is out on my whirlpool gas water heater. © 2023 american water heater privacy ® registered trademark/tm trademark of whirlpool, u.s.a. Allowing air to circulate via the bottom door may be a good idea.turn the gas knob to the ″pilot″ position and push and hold the button.to activate the pilot light, turn the knob to the ″pilot″.

Look through the site glass. Pilot won't light make sure the gas supply valve has been turned on. Fg1j5040t3nv) the pilot won't light,.

The pilot heating the thermopile (the flame sensor in the pilot flame) generates a low voltage. The printed instructions and product labels. You’ll have to manually bend or straighten the thermocouple back to position.

Once cooled down, turn the pilot control knob to light. Push the “pilot light” button next to the knob release the knob if all goes well, you should hear some clicking and a whoosh. Now you will need to.

Use my amazon link to shop. You will hear the clicking sound of the igniter sparking. Whether your water heater is running or.