The problem is that this will not allow.

Tile around electrical outlet. We at akron electricians have a team of licensed electrical contractors serving the entire columbus, ohio area. To properly place a tile around an outlet, you will most likely need to cut it. Then, using a hole saw, cut a hole in the tile for the outlet.

This can be a daunting task but just follow these steps and there shouldn’t be a problem. Lay the faceplate over the outlet, making sure to match up the screw. Before we start, here are some things that you will need to install your mosaic tiles around an electrical outlet:

What i didn't consider was that my wall tile (4' high off floor) would cut right through the middle of the electrical outlet and the light switch. Your best bet is to clamp the tile to a flat surface (like a piece of plywood) and drill a hole at each of the four corners using a diamond coated bit (carbide will work, too, but is slower and dulls. Once you have tiled the wall around the outlet, you will likely have four tiles missing that need to be cut.

What you need to know about tiling around your outlets. Loosen the screws that are securing the outlet to the electrical box that is located behind it to make the tiles fit. You will need to unscrew your sockets to tile behind the front.

Tile the wall to the electrical outlet. When you have cut a hole in the tile for an electrical outlet, it is time to install the outlet into that space. When you cut tile around an electrical outlet, you should keep a few things in mind.

If you have set tile on a kitchen backsplash and need to exte. Trimming the tile to surround an outlet. Need a residential or commercial electrician near you?