I got a 2003 RXDI Seadoo.

Seadoo jet ski limp mode. Remove weeds shells debris or any- thing else that could restrict the flow Check fuel tank and oil reservoir retain- of water and damage cooling system. 50 hour service notice can be reset by pressing set mode described in your booklet. 2014 Sea-Doo Spark Tech Section.

If you can see a Limp home mode message on the dashboard this means you can ride your Sea-Doo but at a reduced speed only and you must head back to the dock immediately. I have a seadoo challenger 2000 with a 240hp merc M2 jet drive and Im having some trouble with it going into limp mode. BTW from what I heard Rotax Powerpack use a slightly different BUDS diagnostic version than BRP Sea-Doo dealer therefore your local Sea-Doo dealer may not be able to communicate with your Scarab boat.

Any sensor can trigger Limp mode. The EMS will activate an error or fault code on your handlebar display if you have a problem with any of your jet ski systems. Repair manual says 3 things can cause it low oil exhaust overheat and engine overheat.

2014 Sea-Doo All genuine BRP personal watercraft parts and accessories installed by an autho- rized Sea-Doo DistributorDealer at the time of delivery of the 2014 Sea-Doo per- sonal watercraft carry the same warranty as that of the personal watercraft. Sea-Doo fault codes are trouble-shooting codes that are stored on your jet skis onboard computer or EMS Engine Management System. Stat here and check these items.

Is it the engine light or the wrench light. My Sea Doo goes into Limp Mode with MAINT flashing on the dash. That is the starting point to solve most issues of the described symptoms.

Brp International Limited Warranty. If I launch the boat start it up and cruise non stop it runs perfect. Since youre taking it in for service tell the tech exactly what first so he can get it on BUDS and read the code.