Get a good still three or four inch putty knife with a fairly sharp edge and using a hammer gently drive it under the crimp to loosen the hold.

How to remove pontoon railing. Remove any screws or pop-rivets that attach the damaged aluminum to the railing. Using a flat scraper pry open the lips that pinch the aluminum paneling to the rails. Set all furniture on the deck and fasten it down using stainless steel fasteners with fender washers.

The boat should be well supported and stable on all three columns and the bunks of the trailer should be about 6 to 8 inches lower than the bottom of the boat. If streaks remain you can remove them with a clean cloth. We build all of our pontoon fence railing to order.

Extend the trailer jack to support the tongue and remove the bottle jack Diag6. Lower the bottle jack. Measure the distance between the inner side of the port rails and the inner side of the starboard rails.

PONTOON BOAT RAILING SECTIONS. Re-install the steering throttle and shift cables. It often looks like new.

This combination allows for the railing to be bent and. This will give you clearance to clean and polish the areas normally supported. The Sphaera fender profile railing offers boaters a chance to re-rail their boat with simplicity at an affordable cost.

Instructions about how to install a Sun Tracker Rail-Lock pontoon boat cover made by Dowco when you trailer your boat or have it out of the water. We build all of our pontoon fence railing to order. But many people dont want to drill a hole in their pontoon rails.