Reset keypad by sliding the cover half way up.
How to program a genie keypad. Genie garage door opener remote and keypad programming instructions. Press the number of the desired door (1, 2 or 3). The indicator light should blink once, alerting you.
Erase the other garage door codes. Install the provided phillips head mounting screw into the garage door casing with a 1/8” gap between the screw head and. Enter the pin number on the keypad.
On the keypad enter the door. Note how the genie is only partially open during this step. Press the prog and 8 buttons simultaneously and hold them down.
Programming instructions for the gwkp genie garage door opener keyless entry involves following the two sets of steps below: Press the up/down key once. On the keypad press send.
Programming the new genie keypad to the opener. Press and hold the program key until the led light changes from. If your remote or keypad is unresponsive, the first thing to check is the batteries.
While holding down on the # and 8 keys at the same time slide the cover up the rest of the way until it. Choose the model of your remote or keypad accessory to find the correct programming instructions. Slide the keypad cover to half way open.