Then measure the two holes from the hardware of your skate.

How to mount skateboard on wall. Screw the plywood plate into the. There you have it, a. In this video i show you how i hung up my boards.

Now you’re going to drill the holes in the wall to hang your board. Clean the wall surface where you will be attaching the adhesive strips. Bear in mind that where the screw is will be slightly above the top holes of your board.

Quick and easy to install, our deck mount. It’s best to have a drill with a 3/8″ drill bit and a hammer drill to make sure that the holes. Peel the backing off of one side of an adhesive strip.

These two additional bolts mark the gap. Make sure it is free of any dirt, grease or debris. Mark the lines with equal distance and equal length.

How to wall mount your skateboardtoday i'm going to show you how to wall mount a skateboard deck in a cheap and easy way! A spanner can be used for tightening these nuts. Place a washer over each of the bolts on the front side of the plate and secure them with a nut.

Drill holes and display the skateboard on the wall. Hang your skateboard’s deck vertically on the wall hanger or nail. Next, add in nuts, one on each bolt again, about halfway.