4 allow the billet to reach welding.

How to make damascus steel without a welder. I like bandsaw blade and pallet strapping as i can start with 20 to 25 layers and so save a. I did 5 7 long pieces, 2 of 1084 and 3 of. You could also use mild steel and some type of high carbon steel, and you could even use sand as a flux.

3 place the billet into a forge that is preheated to 2,300 degrees and soak until the billet is dull red. Flux it and back into the fire. Repeat the fluxing and hammering 3x.

The blacksmith brings these short cuts of steel cables with standard welding tools and forge. Add shims of contrasting steel, such as 15n20 or pure nickel, and then forge weld and draw the billet down. Cut four squares of the steel and stack them into a square billet.

Quick summary damascus steel is a combination of different steels characterized by the wavy pattern of dark and light lines visible on the metal. This is the second billet of damascus, it works just no to plan. This modern damascus is made from layer upon layer of steel worked by the smith and welded into a solid billet.

Take a long piece of 1/2 inch square rod and forge the end out flat and as wide as the pieces in your stack. Tap off excess kerosene and go straight into the fire. Damascus steel was the forged steel of the blades of swords smithed in the near east from ingots of wootz steel either imported from southern india or made.

The length of each piece of steel and the number are purely up to you. I used 1095, a very high carbon steel, and 15n20, a steel with a lot of. This is by far, my favorite combination for making damascus.