Use the compressed air to.
How to clean a shark navigator. It would be best to never use a shark navigator vacuum to clean up water or spills. Replace the shark navigator’s belt. Taking out the base plate.
It is time for you to know how to clean roller on shark navigator. To clean the foam and/or felt filters, rinse with cold water only. Remember that, taking out the roller brush without removing.
Step 1 unplug the shark vacuum. The water can penetrate the motor and damage the machine from the inside. Empty the canister from dirt and dust, then sink it in the kitchen sink or in a bucket full of water and soap.
Remove them to gain access to the interior of your vacuum head. Clean the motor’s filters as precisely as mentioned in the handbook that. Taking out the brush motor.
Turn your vacuum upside down and locate the different screws on the bottom. First tap the release tab upper side of the dust cup. Taking out the circuit board.
Then move it from the main body. Filter set for shark navigators on amazon: The next step is to remove another two screws from under the front wheels.