For lighter items, simply screwing into the plaster with a 1 1/4” drywall screw is usually enough to get the job done.

Hanging pictures on plaster wall. Draw a mark on the. If the pictures are small and equipped with a wire on the back, use a small picture hook and nail. Sew the mesh through the wall as you would everywhere else (18″ on center both directions) to tighten the mesh around the backers.

For pictures weighing less than five pounds, use an adhesive hook or velcro strip. Be sure to take photos of the. Screw the long wooden plaster screws into the two drilled holes.

You will need an electric drill with a variety of drill bits, and screws or classic picture hangers. Mark where a stud is found. To hang pictures on horsehair plaster walls, follow the below steps.

Take a picture hook and drill it. For pictures weighing five to 10 pounds, drive your nail or hook at a. To use them, follow these steps:

Place duct tape on the spot. To ensure they're in the right spot, make two marks on the back of the picture the same distance in from the sides. Using your drill bit, drill a clean and straight hole into the wall, through the plaster and lath.

Use a magnetic stud finder to find a wall stud. Drill holes into the marked areas. How to hang pictures on plaster walls.