Place the filter lid over the lower tank half, making sure it is fully and firmly seated on the tank half, see figure 1.

Clean pentair pool filter. Backwash the filter for 3 to 5 minutes again to remove dirt and debris that has been dislodged by the filter cleaner. After the lid comes off, clean the inside bottom of the lid. Make sure you do not use too much pressure while rinsing the dirt off.

You should also dismantle and clean the. If you find any damage, replace the damaged parts at. The quickest, easiest method is to use d.e.

Place lock ring over the tank lid, and centering the lock ring on the threads of. After doing all of the steps, take the new pentair. Remove inner grids and check for any damage.

Turn the clamp and lid set in order to remove the clamp and. Slowly add the sand filter cleaner into the skimmer. How to tear down and clean a pentair clean and clear plus filter inspecting a pentair clean and clear plus filter before tear down and cleaning.

Add pool filter cleaner into the empty bowl then add some water until the cartridges have been thoroughly submerged in the bowl. If you need to clean the filter the casing comes right apart. Turn the pump off and place the.

These manufacturers recommend deep cleaning their filters once a year, and there’s a very good video tutorial you can follow here. This will keep water from entering the filter tank while you’re performing maintenance on it. Here’s how to get started: