INSP JET PUMP UNIT JET PUMP UNIT Impeller inspection 1.

Yamaha waverunner jet pump bearing replacement. Remove the jet pump unit 1. Shift cable joint jet pump end Adjustment steps. Jet pump parts for Yamaha.

If the steering cable cannot be properly adjusted by the cable joint at the steering mas- ter end adjust the cable joint at the jet pump. Yamaha WaveRunner III 1992 Jet Pump Repair Kit by WSM. Needle bearing attachment jet pump bearing and oil seal.

1 x 93306-20654-00 Bearing 1 x 93306-30582-00 Bearing 1 x 93102. Yamaha WaveRunner GP1300R 2003 Jet Pump Replacement Wear Ring by WSM. Housings Wear Rings.

The following procedure applies to all of the connecting rods. 64 N m 064 kgf m 46 ft lb NOTE. Page 50 INSP CONTROL SYSTEM 2.

Jet Pump Rebuild Kits. Also with the pump in your hand spin the prop and shaft you should feel some kind of grind if the bearing is bad. Replace plastic liner for a fraction of the cost of new pump housing.

00160040 mm 0000600016 in Measurement steps. PWC Performance Parts OEM Yamaha Pump Bearing and Seal Replacement Kit YAM-BEARING-KIT - Its recommended to replace the bearings and seals when installing your shaft into any new replacement pump. I think honestly adding a vent tube with a cap would be a better way to make that bearing as you could replace the grease by pumping it in and catching the old grease plus you would get a heads up if your seals were leaking by inspecting the old grease exiting the bearing housing.