By and large a drop link is used to connect the end of the anti-roll bar to the damper or a control arm.

What is the purpose of a drop axle. Installed between the axle shaft and the front differential on independently-suspended front suspension four-wheel drive trucks the axle spacers maintain adequate axle travel and suspension movement once the lift kit has been installed. The axle is lowered when it becomes necessary to help spread the vehicles weight over a greater area. These are also able to be lifted when not in use.

This allows the tires to avoid unnecessary wear and also saves fuel. This type of axles are primarily provided to support the main axles and to increase the GVW of the truck or bus when there is no need of twin tyre axles. You can lift the axle which will lift the tire off the ground so that you dont use the tire when you dont need the extra axle which will save on tire wear.

The spread of the two axles is 102 counting them as two separate axles that can each carry 20k lbs. Drop axles are also significant from a legal standpoint. The centre is dropped.

Sometimes they are called lift axles because on some big trucks these axles can be lifted up to prevent wear and tear on the tires. In most instances the drop link is used to ensure that the load is orientated correctly and to bridge the gap between the anti-roll bar and the connection. It is the job of the drop link to transfer the roll stiffness generated by the bar.

It is also possible to find a tag axle on farm equipment as. Currie High Pinion Assembly. So not only do the extra wheels help bear.

Although it is not required it is recommended that you apply a light amount of grease to your Mountain Bike axles. This not only makes them easier to install and remove it also helps prevent rust and corrosion. Torsion axles work by using rubber cords or cartridges inside the axle tube to handle suspension travel and shock absorption.