Attach the vacuum head to the end of the pole.

Vacuum pool without going through filter. First, you need to prime the vacuum. If your swimming pool has a large amount of dirt try vacuuming it using the pool filter's vacuum to waste setting, if it has one. Second, connect the open end of the hose to the skimmer inlet.

This bypasses the filter unit, sending the water to the pool's. To sum things up, using a sand filter to vacuum a pool is a. The pool starts filtering normally by switching the valve to filter position through turning on the filter.

You need to attach the vacuum head to your. That said, you’ll be following these basic steps: Next, to remove air bubbles, you have to push.

Plug the end of the vacuum hose into the skimmer port to initiate suction through the vacuum line. Attach one end of the hose to the vacuum head and attach the other end to your skimmer using the vacuum plate. Such a pool has an average capacity of between 2,000 to 2,500.

It will make your vacuum strong. To do that you need to remove the air in the system. 130 * 50 * 22 cubic inches.

(skip this step if you have a doughboy pool.) turn off. Brush your pool and then vacuum up all debris. If you vacuum on a waste setting, you will need.