While generally associated with the backwoods whiskey still, the thump keg, or “doubler”, is a very old design element that.

Thump keg design. What is a thump keg used for on a moonshine still the kgb new 20l alcohol moonshine copper still distiller stainless boiler. Save the thumper juice to top off the boiler. Tiny young girls in pigtails.

Thump kegs do come in a variety of designs. The thump keg is named after the thumping sound that is made from the steam being forced under the level of alcohol in the barrel. Take your 54mm to 15mm reducer and slot a 15mm piece of pipe in it (9cm in length) making sure to put on your flux, just solder it in place.

As the wash boils in the potstill, heated vapors are drawn into the thumper keg via a swan neck. It allows you to distill the. The thump keg is one of the most ingenious and iconic design aspects of the classic hillbilly still, and its purpose can be summarized as follows:

The design of a thump keg. It will also be very. Now add a 15mm copper elbow, 90 degree, not.

Run 2 from my big keg down to the bottom of my little keg, insulate all the 2 going to the thumper since it is on the outside, then fill the thumper up 2 to 4 higher than the hole. A thumper keg is a barrel or thumper chest that is known to distill whiskey, bourbon, or wine. By heating the liquid again,.

With a thump keg, the hot vapor that exits the still arm into the wine that is already condensed at the bottom of the thumper once again evaporates before it reaches the. The primary function of a thumper keg is to expedite the distillation process. You’ll start to hear a thumping sound as the vapor and condensed low wine erupt out of this pipe every so often.