Activate keypad by opening battery compartment and pull protective tab.

Programming a genie keypad. Press the program key on the keypad. Tab for questions or troubleshooting, contact customer care by. (red light blinks) enter the personal identification number (pin) of your.

Press and hold the program and up/down keys together for approximately 5 seconds the led will flash twice and all lights will go out indicating the keypad has been reset. This pin must be 3 to 8 digits. Programming your intellicode keypad open cover fully until it latches.

Enter your dip switch sequence from. Garage door opener remote programming. Garage door opener programming instructions.

On the keypad enter new pin number. If you need to program your genie garage door opener remote, here are a few quick and easy steps to follow. After step 1 below, perform the next steps while the keypad backlight is on.

Press the prog and 8 buttons simultaneously and hold them. 1 hold down prog+6+up/dwn, the red led light on the keypad will go out. (red led flashes 1 time per second) 2.

Step 1) programming a pin number program the keypad for the first time* with a personal identification number (pin). Genie garage door opener remote and keypad programming instructions. Part 1 open the genie intellicode keypad cover halfway.