Lay the faceplate over the outlet, making sure to match up the screw.

How to tile around electrical outlets. Instead, aim to bring the tile to the buffer area between the faceplate perimeter and the outlet box perimeter. Start your tile installation from the left bottom or right bottom of the area you plan to tile. The cover plate comes off, and then you'll see each outlet and switch has little ears on top and bottom.

Clean the corners of any other rough. When you cut tile around an electrical outlet, you should keep a few things in mind. Remove the freed section from the tile.

Place the paper template over the area, and press it against the tile. I have seen switches and. Poke holes in all four corners where you will need to cut out the shape of the electrical box hole using a glass.

Remove the clam to free the tile from the plywood board. The easiest way to mark. You want to have around 2mm of tile behind the faceplate, being sure your tiles won’t obstruct the mounting screws when you come to put everything back together.

If you have set tile on a kitchen backsplash and need to exte. These ears must sit on top of the tile when finished. Your best bet is to clamp the tile to a flat surface (like a piece of plywood) and drill a hole at each of the four corners using a diamond coated bit (carbide will work, too, but is slower and dulls.

Where you start is up to you (as long as you start from the bottom). Pry the box loose from the stud, deal with any staples that may restrict movement and slide it to it's new location and rescrew it thru the box to the wall. First, mark the location of the electrical outlets on the back of the tile.