To tap the keg, simply pull out the handle located on the keg coupler.

How to tap a kegerator. Make sure to get your co2 tank filled at your local gas supplier as all tanks are. Use of a dirty glass. Place the draft tower on top of the opening and secure it with 4 mounting screws.

Now, attach the other end of the. Make sure the black pull handle of the keg coupler is closed as you insert the keg coupler into the beer keg. And then we drill a 2 1/2 inch hole right.

It also adds an extra touch to your bar. The keg is now tapped. Feed the air hose into the draft tower from inside the cabinet.

If the keg is not properly chilled, the beer will be overcarbonated and will cause foam. Place both the faucet parts and keg coupler in a bowl of warm water. To relieve the pressure in the key, turn the keg over and push in on the ball with.

Without a tap, how to tap a keg on top of the key, locate the pressure ball valve in the middle of the tap fixture. It also shows you how to set the pressure of your co2 tank and how to pre. Repeat step 1 with the liquid post (make sure the tap is closed) push the pressure relief valve on top of the corny keg to release the co2;

Here is a few tips to help you stay clean and save your beer from foaming. Basically the plan is to remove the plastic top, reinforce the area under the plastic lid with a board to make sure the tap has a nice solid base it's on top of. First, align the coupler with the lugs on your keg and turn clockwise about a quarter.