1) jammed, broken, or damaged recoil starter assembly.

How to start a generator with a broken pull cord. Hook the knot on the notch and wrap the rope as tightly as possible around the wheel. Open the fuel valve and choke. For that, follow the following steps:

If you see the pulley has cracks or is broken, it’s time to replace it with another one. If the recoil rope gets tangled, the spring or. The new part broke in the 1st pull.

Simply attach a breaker bar connector to your impact driver or your power drill, shift your tool down to a low speed, and then slap the socket on the end of that connector. I bet after reading this article, you can have a good picture of how to start a generator without pull cords in case it happens to you. Your generator might be hard to pull because of the recoil starter itself.

Your knot should be almost. As a general rule, a generator will be hard to pull start due to hydrolock in the cylinder, a malfunctioning recoil. You’ll need to inspect the integrity of the pulley by removing the starter and checking any damage on its parts.

Fit a socket that will fit the flywheel nut to your power drill. Turn the fuel line on. 1.remove the bolts that are holding the cover.

After you filled up your generator with gas and all the necessary cleaning has been done, this is how you start it: But in the mean tim. We were left in a terrible position, but had.