Make sure the paint is fully.

How to paint a panel door without brush marks. Painting a door without leaving brush marks behind: Before you start painting the door, you have to sand it down first, regardless of whether it is a new or an old one with the existing paint. While painting, hold your brush at an angle to the painted surface.

Remember that each part of the door has grains going in different directions. Mix 1/3 paint to 2/3 water in a container. Otherwise, once the paint dries up, you may have a harder time peeling off the tape.

Cut in the areas around your trim and paint the recessed areas a paint roller won’t reach. All things being equal, before embarking on any project, you want to. Apply your first coat of primer and lightly sand with a fine sanding sponge when the primer is dry.

Keep 2 jars with water while. Paint in the direction of the door’s grain. And yes, you won’t leave any brush marks either.

Use a paint brush to cover the trims and panels. 1) the first area to paint is the door jamb (door jambs are the sides of the door frame that run vertically). Now you are going to apply another coat of primer, let dry and sand again.

For inside surfaces, use a 3/8″ nap roller. Dip the tip of the brush in a jar with clean water before you dip it into the paint. For best results when painting doors and jambs, use a paint roller.