Place your pressed flowers and leaves onto the first layer of resin.

How to make resin flower earrings. Once the colored resin in the bezels are cured, it's time to add the flower resin cabochons. You could also leave them flat on a table as long as they have a bottom to support the resin. Flip over your mold and cure once more from the underside.

I needed to do the process of the drop twice, as i only have one mold. Add in two or three gold flakes using tweezers and ensure they’re covered in the resin. Mix a small amount of resin in your mixing cup, according to the directions on your resin packaging.

Place your flowers on a silicone mat, this will make it easier to remove the flower once dry. This is not a technique i have ever tried before so i'm anxious. Place your uv lamp over the resin in the mold and cure it according to your resin’s instructions.

Start it as you did above, with a thin layer. Squeeze out a small amount into the center of the bezel (just enough to make a thin layer that touches all the sides of the bezel) being careful to not to go over half way full. In today's video we are going to be making some cute earrings out of dried flowers in resin!

Making the resin flower earrings 1. Resin artist tai eliades shows us how to make resin earrings using pressed dried flowers.read about preserving dried flowers here: Resin is a wonderful glue in itself.

Using the stir stick, carefully dip your stick into the envirotex mixture and then pour a small amount of resin into the jewelry resin mold. Set up your work area and put on your goggles and gloves. Place and arrange the hydrangeas inside.