Run a flooring roller over the vinyl to press down the flooring and remove any bubbles.

How to install rubber vinyl flooring. We recommend leaving a gap around the rolls roughly the thickness of the rolls being used to account for expansion and contraction. Place the roll end against the. Second, old vinyl flooring may not be compatible with the new vinyl flooring, which can also create problems.

In the image below you can see that our installation team has cut and trimmed the rubber for inlay platforms and are now ready to add adhesive to the red platform and gray dropzones. Press bubbles out of the vinyl sheet. Use a rubber mallet to tap down on the seam to click it into place with each end of the plank.

If yours is uneven or slopes, it will need some attention before you lay your flooring. How to install vinyl flooring: Glue or use utility tape to fasten.

Check the first row of planks for proper fit. Use a small hand roller over the board surface to make sure the piece sticks solidly. Another important thing to consider before you install vinyl flooring yourself is the climate in your home.

The floor is glued down to the floor joist, and then the. This method is the most common method of installation. When properly cared for, your rubber floor will last for decades.

Apply a thin coat of finish and allow it to fully dry (avoid aggressive fan forced drying that may. Mix the pieces together to create a more uniform appearance on the flooring. The subfloor needs to be clean, level and dry.