Consistency is key when wall hanging:

How to hang up a skateboard. A screw should be included with your deck display. The length may vary dependent on the skateboard, it needs to fit around the wheels of the board after allowing for the two. Use a hammer to keep the wall secure.

Attach a wall anchor by drilling a hole into the wall. Hang your skateboard’s deck vertically on the. First, drill two large holes in between where you want your board (s) displayed,.

Make a mark on the wall where you want your screw to go in. Mount the pushpin to the wall. Peel the backing off of one side of an adhesive strip.

Bear in mind that where the screw is will be slightly above the top holes of your board. Clean the wall surface where you will be attaching the adhesive strips. Once you have the measurement, you will need to draw two dots (the.

Make sure it is free of any dirt, grease or debris. How to hang up skateboards without putting holes in your walls. If you want your deck to be hung, you’ll need to drill a hole in the wall.

Hold the display against the wall and align the hole at the center with the one you drilled in the wall. Thread a screw into place. Once you insert the nail or wall hanger in the wall and your deck is ready, simply hang the skateboard on the nail.