Clean the garage door sensor.

How to align garage door sensor. The sensors have been exposed to direct sunlight for so long. You point the sensors straight at one another until they are aligned properly. Rather than wiggling the brackets themselves, the easiest way to go about this will be loosening the wing nut that screws into the sensor.

Most units will have lights on. If you have a safety beam out of line, the fix is pretty self explanatory. You will see that one sensor is mounted higher than.

Albert, a country classics employee, explains how homeowners. Albert, a country classics employee, explains how homeowners can align their garage door sensors if they stop operating. The sensors are usually located on the sides of the garage door near the.

To align your garage door sensor, you will need a ladder and a screwdriver. Use a ladder or step stool to reach the sensors. Unfasten the screws holding the sensors, and then slide the garage door sensor downward.

In some cases, a wing nut will. First, locate the two sensors on either side of the garage door. Once you have found the sensors, you will need to adjust.

When all of the preceding measures failed, the following method will show you how and when to adjust garage door detectors properly. Once the wing nut is loosened, realigning the sensors. Locate the two sensor eyes at the bottom of the garage door track on either side of the door.