Let’s look at the g wire.

Honeywell non programmable thermostat install. 2) align the two brackets on the top of the thermostat with the corresponding. • common wire with battery backup. • warm air, hot water, high.

• gas, oil or electric heat with air conditioning. C wire adapters are available here. Do not install in locations where the thermostat can be affected by:

Install the thermostat about 5 feet (1.5 m) above the floor in an area with good air circulation at average temperature. About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features press copyright contact us creators. 2 mark positions of both screw holes.

Align the 4 tabs on the wallplate with corresponding slots on the back of the thermostat. Mark mounting position 1 level base or cover plate if desired. If you have a c wire, place it into the c terminal on your wall plate.

Enter installer setup by pressing and holding the up and fan buttons, at the. Other models may vary these diagrams are also available within the ecobee3 lite installation guide included with your ecobee3 lite thermostat for the y, y1, and y2 wires, y or y1 will go. This wire goes to the g terminal on your new.