Apply a slight bit of pressure while drilling.

Drilling tiles fast or slow. Then, align the two brackets using a. Repeat this process for any other holes. A cordless drill without any bells and whistles suffices for drilling through tiles.

For a written explanation see below for our 6 simple steps which explain how to drill into tile, including: Once you have measured where you want your fitting to go, mark it on the tile. You can also add a little pressure to get through the rest of the tile to the wall.

Follow the five rules below for a step by step guide on how to drill tiles: Use an arrowhead tile drill bit (or a pointed masonry drill) and before you attach it to your drill. So start slow and with a small bit.

At this stage, your fast drilling could damage the tile and can break it. A normal drill bit won't even mark a porcelain tile. Going too fast will cause your drill to overheat, which is.

For example, if you want to install towel bars, you should mark the two mounting brackets. As the bit penetrates the tile, it’ll create a pile of dust 2. Put a drop sheet down to protect your floor.

Using an impact drill will yield a good result too, as long as you turn off the impact function. The general rule is measuring twice and cutting once. After you successfully drill through the glazed surface of the tile, you can drill a bit faster.