To drain your hot tub with a hose, follow the following steps:

Draining a hot tub with a hose. It is a quick guide for draining a hot tub so that you can have an idea of what. Follow the pipe flush process prior to draining. Unplug the hot tub or turn off the circuit breaker to prevent the hot tub from being turned on accidentally while you work.

Locate the drain, which is usually located near the base of one of the exterior cabinet sides. Be certain to hold the kink in the hose until you get the end that you are holding below the level of the hot tub itself. How to connect a hose to your hot tub to drain it.

Run out the hose to a convenient area of the garden where the water can drain out or into a sewage input/drain. Or you can use a submersible pump which takes about 15 minutes.****. Place your submersible pump in the hot tub footwell or deepest point.

Pull the drain out (usually with a slight clockwise turn), then. You can easily clean a hot tub without. Make sure you have your ph,.

Turn the power to the spa off at the circuit breaker. Drop the hose into the tab, make sure it lands in the bottom, and then turn it on. Drop one end of a long vacuum hose into the spa, and connect the other end to the wet/dry.

Turn the power back on and add your pool chemicals. Turn the power off and connect the pump. Finally, reconnect your power source and turn the hot tub back on to begin circulating the water.