Then the 24″ x 24″ plywood board on top of the foam.

Diy reupholster ottoman. Use an electric drill to drill pilot holes into the. Important note if you're going the diy ottoman route: That might be a teensy bit more.

Place the upholstery foam in the center. Then skip straight to create a new ottoman cover. the steps from that. The ottoman i built is 36″ x 22″ and approximately 14.5″ high and the plans reflect the same.

The first thing that you need to do is to cut the wood properly. Again this is a technique used in larger. I like the idea of a muslin covering, though.

This beginner’s guide is for all diy enthusiasts. If yours has a hinged. The top of the ottoman is the easiest part.

Making sure that the batting is centered and spread smooth. The ottoman shown above is assembled. Cut your 2x4 wood into 4 equal pieces.

Right now, my ottoman is wearing a big gray beach towel. This one measures 36 inches wide, 25.5. Lay a sheet of upholstery batting over the foam nice and taut.