It is fairly simple and you can do it in about a.

Craftsman garage door opener reprogram. Next, put the handheld device that came along with your garage. If the light flashes, don’t be alarmed. Now that you have located the learn button of your opener, it is time to use it.

Press the ‘learn’ button again and thereafter you will see the light come. You should find a button there that’s labeled. Reset the memory of your opener.

Press and hold the button until the adjacent light turns off. This shows that the old code has been erased from memory. When your craftsman garage door opener is.

Next, you will go to the keypad attached to the wall to program the new code. In this video i teach you how to program, reprogram, set, or change your craftsman garage door keypad code. The first thing to reprogram a garage door opener using a keypad is to find the ‘program’ button on the keyboard, then the ‘6’ button, and the ‘up/down’ button.

1) locate the smart button on the motor head which is directly under the screw terminals where the push button. Return to the installed garage door opener and locate the srt button on the back of the garage door opener. Find and press the “srt” button.

Remove the housing protecting the light bulb. You have now cleared all codes that were used, including the remote garage door opener. Hold down the button for about 25 seconds until the lights turn off.