You may find some of these items are cheaper from Amazon through the links at the bottom of this post.
Catalina 22 anchor. The hanger comes with two vinal pads for the slighly smaller pulpit rails on a Catalina 22. Our boat is a 1985 Catalina 22 so different parts may be needed for other model years or if you have non-standard gear. Like a mirror it reflects the shadow of the boat and anchor.
The factory suggests about an 8 to 12 pound Danforth type anchor. The length of a Catalina 22 hull is 215 feet a foot and a half under the minimum length for a mandatory anchor light. Honda 5 hp 4 cyc longshaft with.
We ordered a bunch of parts from Catalina Direct. This anchor is only effective with 10 to 20 feet of 14 inch or heavier gauge chain and 150 to 300 feet of 38 inch or heavier nylon line depending upon the depth of the water the size of swells wind velocity and changes in tidal levels. I had a chance to try out one of my Anchor Rode Storage Buckets.
More specifically slide the pipe into position. The clearances on all of the other bridges at the center are well beyond our masthead at 291 feet plus our VHF antenna above water level. My chain length is more than most would use on this boat.
Also be aware that you will need two 10mm wrenches as the nuts and bolts are metric. We dropped anchor just outside Fords Cove so the kids could do a little swimming and tubing off the back of the Christopher-Jin. Attach the pipe at the outside of the hull with the inner end protruding about 38 into the anchor locker.
Were the first and last stop for parts and accessories. Its hard to argue with the construction of a boat after 10000 have been built but we do. I have an 81 Catalina 22 with a little locker at the tip of the bow.