The WaveRunnere engine wont turn over at all.

Yamaha waverunner will not turn over. Lock mode selected Engine shut-off switch. About 2 weeks ago It would not start due to bad or dead battery. Also when trying to crank it if you have a choke engage it.

Take a small hammer or other hard tool and try. It will not start or turn over. Do you have a different model Yamaha ATV.

If you pull the spark plugs and it still wont turn over then the next place to look os the starting system itself. The engine carburetor is located on the right side of the WaveRunner so when turning the WaveRunner upright always rotate it in the clockwise direction as seen from the back of the WaveRunner. If you need to do a self-diagnosis on your Waverunner then with the engine running press the select button 1 for 8 seconds and look for an error code.

To avoid this cancel. And make sure battery is up to full charge. Yamaha Outboard Cranks But Wont Start Will Not Turn On - YouTube.

It turns over but does not startStill re check battery voltageIf the battery voltage is low its battery issueIf the battery voltage is low then also engine will turn over but due to low battery voltage it will not turn the starterSo first check battery voltage and battery connections and confirm that its not battery issueThe battery voltage should be between 115 to 125 voltsIf battery voltage checked ok and its. Here are some picture of where the Yamaha VX1100 Waverunner voltage regulator rectifier is located and what it looks like close up. Mine does this when I havent cranked it in a while and my husband turns the idle screw found on the motor on the inside of the ski.

If your ATV turns over but wont start it means the starter has gone bad and youll need to buy a new Yamaha ATV starter. It just doesnt seem to want to start from the switch push the switch it will cycle the fuel pump and has lots of presseure but it just will not start Im fairly mechanicly inclinde but this is my first waverunner and not positive what it could be everything does turn freely pump motor with plugs out have had it running with starter fluid but just will not turn over. Check the engine shut-off switch.