Yamaha Jet Ski Won't Start Just Clicks

If the Jet Ski does not start and cannot run at all then the engine ignition is the first place where you should look at.

Yamaha jet ski won't start just clicks. If it still does not it is the starter. Make sure the clip is in place. Does the starter relay in the ecu box click.

Lock Mode is active. There may be something wrong with other components of the jet ski causing it to fail while starting. Never go off on what a voltmeter says but instead what a load tester says when checking if a battery is good or not.

After power and ground are verified its either the signal to. Even if you have a new battery and your Yamaha ATV wont start a simple test light and a digital voltage meter can help you identify the problem. The reason you should still fill your gas tank before putting your jet ski away is to limit the amount of air space left in the tank.

Put the engine in drown mode by holding down the throttle all the way you can put a rubber band around it to hold it open then press the start button. You can usually hear the starter hanging up when attempting to start. Troubleshooting of a jet ski that wont start can be broken down into a few other groups.

Ive rebuilt the carb replaced the spark plugs and replaced the fuel lines. If bad voltage at the starter measure the voltage at the solenoid small input terminal from keyswitch with key turned over to start. This video will detail the.

It will not start or turn over. Occasionally on a jet ski or waverunner youll run into issues with the starter being your culprit. I dried it out but since then when it was running the starter motor would kick in.