The Wave Boat uses the PWCs engine and steering and just locks into a boat frame providing more space for others to join you on your adventures.

Wood boat with jet ski engine. There is a jet. The boat is ply on western red cedar frames the bottom is moulded in ply. 19 Torpedo - classic inboard runabout.

The jet ski can be attached or detached to the boat in seconds which makes this setup flexible. The outboards transom makes that boat 2 inches shorter than the sterndrive. Choosing a too-small engine could be a hassle but on the other hand too much performance is not desired either.

This boat hull had been abandoned in the woods for over 20 years. I was going to cut it into pieces and haul it away but it had that old style you dont se. The engine is in the hull of the boat while there is a prop and outdrive to the exterior.

They take the Jet Ski apart cutting out the motor and pump part of the hull and install it in the boat by cutting out an appropriate sized hole and bolting it in. So Ive been thinking about buting a new jet ski and salvaging the engine and drive train. My boats are light weight deep V hulls that dont require a lot of torque to drive them.

The jet is 18 inches longer than the other two because its extended swim platform is a standard feature. The outdrive turns to steer the craft and can be trimmed up and down. An InboardOutboard IO for short is a combination.

For a propeller or a jet drive the maximum possible efficiency is. The closed loop system is mostly like a cars engine. Building and innovating Jet ski made of marine plywood and wood.