This system has a powerful 2.4 gallon per minute.
Winterizing an above ground pool with a sand filter. Clean and store the filter and pump step 8: Replace your filter cartridge, so that you will have a clean one once the new pool season starts. Backwash your sand or de filter, or if you have a cartridge filter, remove the cartridges to.
Drain all the water from the filter and put the cap away in a place where it will be safe until the pool is ready to be used again. Gut your skimmer, removing all the internal parts and put a rubber plug in the return line (the line that goes to the pump and filter). Firstly, you want to protect the three major components of your.
Use a winter chemical kit step 6: Step 4 remove the pressure valve from the top of the sand filter. Lower the water level step 9:
Clean the pool filter after the pump has been running for at least eight hours, it's time to clean the filter. Remove the drain plugs step 10: The first step is to gather your winterizing ingredients.
This is everything you’ll need to get the job done in just a few hours’ time. If you have a sand filter, you want to be even more careful, as it can be difficult. Drain and plug your lines step 7:
Winterize the skimmer, pump, and hoses. To remove the remainder is to use a high volume shopvac to blow the filter out. If you’re trying to winterize an above ground pool with a sand filter, then the first step is walking over to your multiport valve and set it to “winterize”, or any equivalent setting that allows the.