Put the flame from the.

Whirlpool water heater pilot won't stay lit. Here are the top reasons your pilot won’t stay on and the various method which you can adopt to fix the issue: If it doesn’t, remove the tube and clean it again. Dirty pilot tube if dirt and debris can collect a pilot tube in them, then there are.

Thermocouples need heat from the pilot flame to keep the gas valve open. The pilot will not stay lit.i replaced the thermopile assembly. The following are the most typical reasons why the pilot light on your heater won’t remain lit:

There's also an led to note operational status. This wh has a very poor history.american recalled gas valves on 2001 models because the. Your appliance needs air to keep the pilot light igniting;

In some cases, dirt or other particles block the thermocouple from receiving an electrical signal from the pilot light. Light your match or you can use a lighter. When the water gets to.

A failed limit switch 1.3 03. If the water inside is cold the pilot and subsequently the burner will light. After a minute, when the knob is released the pilot light goes out.

When you’re done, test the heater on and see if the pilot light stays lit. As a result, it may shut off the gas flow even when the pilot. While holding the knob to start the pilot light the led blinks once.