Powered down for a few minutes, held control lock.

Whirlpool washer control locked light on. If the control lock on whirlpool washing machine is really locked, then you may need to go ahead and take your old washer to the manufacturer to get it. Instructions for turning this feature on and off varies by model number. First, check over the door to ensure that the machine is not in a spin cycle.

A whirlpool washer displays a loc error code when a control lock enabled has been detected by the internal electronic diagnostics. If that does not do it, try putting the machine into. The door locked flashing light might generally indicate two things.

Please review your owner's manual for specific instructions. The steps below show you how to replace the door strike in your whirlpool front loader washing machine…. If your whirlpool washer door is locked and the light is flashing, there are a few possible causes and fixes.

That is, there are issues with the drainage system, and the faulty drain pump has to be replaced right away. To use the control lock feature: As a safety precaution, make sure to disconnect the appliance from the.

Love it when i can figure out how to fix it without calling my husband! I have a whirlpool duet washer that has a control lock light on and i can't get. Select and hold end of cycle signal for 3 seconds until the control locked status light turns off.

To do this, turn the water supply off, then use pliers to. First, switch the breaker off, or unplug the washer for at least 1 to 2 minutes. One way to reset your whirlpool washing machine is to switch off the appliance, unplug the unit, and leave it untouched for about 15 to 20 minutes before powering it on again.