A whirlpool washer displays a loc error code when a control lock enabled has been detected by the internal electronic diagnostics.

Whirlpool washer control lock light on. If the control lock on whirlpool washing machine is really locked, then you may need to go ahead and take your old washer to the manufacturer to get it. Whirlpool front load washer 'hold control lock button 3 seconds' light is on. Washer will not run because.

One way to reset your whirlpool washing machine is to switch off the appliance, unplug the unit, and leave it untouched for about 15 to 20 minutes before powering it on again. How to set the control lock: Check for any kinks in inlet hoses, which can restrict water flow.

If possible, remove the inlet hoses from the back of the washer. Press the button for that dedicated key to. If the control lock feature has been enabled, the control lock light will flash 3 times indicating that it is activated.

Before you can unlock your washer, you need to make sure it’s plugged in first. Powered down for a few minutes, held control lock. That is, there are issues with the drainage system, and the faulty drain pump has to be replaced right away.

How do you reset the control lock? If the door locked light is blinking and you cannot open or close the washer door, there may be a problem with the control board or. Instructions for turning this feature on and off varies by model number.

To use the control lock feature: To do this, turn the water supply off, then use pliers to. Tried holding for various times with no response.