I took everything apart and clean it.
Whirlpool gas water heater pilot light. Whether your water heater is running. It’s also wise to look for any visible damage that might cause gas leaks. When the gas burner comes on, use a 50/50 dish soap/water mix to test the screw joints for.
Push in the knob and hold it in. If the pilot flame is not observed then the gas control knob is set to the off position, wait 10 minutes for the thermopile to cool. If you have a newer model, this is when you will need to press the ignite button to spark the gas.
Turn the gas off to the water heater and press the piezo igniter. Whirlpool gas water heater pilot light will not light up. Check if the wire connection is tightened correctly.
Turn the knob to “pilot light”. Gas leaks will reduce the amount of gas reaching the burner. 1 turn the gas valve to the ″pilot″ position and press the button on the valve.
This is the one thing that's worked amazing to get my hot water heater pilot light to stay on! The igniter works, no clogged, replaced the thermocouple. Support this video by clicking on “thanks” and donating.
Make sure the gas supply valve has been turned on. Whirlpool gas hot water tank pilot wont light Once lit you will need to hold the button down for a while to ensure that it keeps burning.