Leave a comment post navigation.
What to use to cut vinyl flooring. You need to exert enough pressure on the knife to be able to make your cut go at least more than halfway. If you’re going to shorten your vinyl plank, you can. The blade is made to make straight cuts, while the roller is for curves, providing pressure for clean cuts without damaging the vinyl.
Measure in from the side near both ends of the plank, and make a small mark where the cut will be made. Use the utility knife to score deeply along the cutline. The best tool for cutting vinyl flooring is a tile cutter.
Use a utility knife to score the vinyl along the marked line. Then, cut each square into four 4’x8′ squares, and so on. Use a tape measure to measure the room and mark the vinyl accordingly.
The technique you’ll need to use will depend on the direction of the cut you need to make. If the width is less than ⅓ of a plank, cut roughly ⅓ of the plank in the first row. Use a straight edge to snap the vinyl along the scored.
Firmly run the utility knife along the edge of the straight edge to score the tile that needs. Use your utility knife to score the tile. To cut vinyl planks with a utility knife, you will need to follow a few basic steps.
Leave a comment cancel reply. Some of the main tools used are spacers to allow efficient installation, rubber mallet to gently tap on the. Tools to cut vinyl plank flooring.