We first need to turn the knob from “off” to “pilot”.
Water heater electronic ignition won't light. With the ignitor still disconnected from the furnace wiring, take the reading. The procedure for properly lighting a pilot. Any reading from 40 to.
Turn the knob to the ″pilot″ position and allow gas to flow to the pilot light. In this case, you need to replace the ignition control module to solve the problem. To light an electronic ignition water heating system, you must first turn off the power supply to the unit.
Lighting an electronic ignition water heater; Turn the power back on. If your gas water heater has an electronic ignition system, you should never attempt to light it by hand.
Mv (main valve), pv (pilot valve), and pv/mv (common). Well, there are a lot of chances when the pressure sensors got repairs, they won’t light under a lot of. If the pilot light for your water heater does not properly work or produce only lukewarm water, the possible problem is that it may have been distended.
Some water heaters use an igniter to ignite the gas. On the atwood model in the image above, you then need to turn the knob past “pilot”. If the igniter fails, the burner will not light.
Then, remove the access panel located on top of the water heater. How to light a gas water heater pilot light. Turn the pilot light knob to “pilot”.