I made everything but it a 20 transom and a 20 200xs merc.

Tritoon motor height. I need help with a new to me Premier 260 Sunsation tritoon. Just mount the motor full down. 3000 rpm 15 mph 3500 rpm 19 mph 4000 rpm 23 mph 4500 rpm 26 mph 5000 rpm 30 mph.

Motor pods can be made for 20 inch motors or 25 inch motors. Im in the second motor mount hole but the engine is low. I was able to take it out for a spin earlier today and had some issues.

I have a 2003 Triton Summit Platinum 250T 25 ft. A 50 HP motor on a 20 foot toon is going to want all the bite it can get. What is the correct height to mount the engine on the transom.

This reduces the power of the propeller especially its push on water. Engine Height For DF200 Powered Tritoon 09-25-2017 1057 PM. A transom thats too high will not let you adjust the trim of your motor properly since you will not be able to increase the angle between the motor and the boat.

Before I move it up I was looking for a reference measurement as it is quite common in setting up a boat to measure from the bottom to. For a propeller to best satisfy particular boating needs the engine must be attached to the transom at the correct height. Power is a Mercury 150 4S.

This configuration was very good and hole shots were not a problem and at WOT 5500 5pm she would run about 53 mph. The digital readout says 30. With normal load 50 gas get someone to take it up to cruise trim it normal and go back and look at the big anti vent plate above the prop on the lower end.