You can use any glitter with epoxy resin, but you have to suspend the glitter in the resin.

Suspend glitter in resin. I’ve been using the castin’ craft clear casting resin and the main glitter i’ve been trying has been super fine glitter. Pour an initial layer of resin, about 1/8 inch, over the surface of your piece. I’ve searched through the forums a few times, but haven’t.

Most craft glitter is plastic, which weighs more and will typically sink. If your object isn’t waterproof, spray it with hairspray before dipping it into the resin mixture. Glitter has been used in many ways.

Luckily, there are ways to prevent this from. Although glitter is very small, it is a solid that is heavier than resin, which causes it to sink. This partially cured time is also known as a resin’s gel time.

You can tint resin with different dyes and powders, and mix in glitter/sparkles/etc. The challenge is when you want to suspend or place something inside the clear resin in a specific position or pattern. One way to suspend glitter in resin is by using a clear casting resin.

You can do this by adding a little bit of silicone oil to. This is a great way to add some cool effects to your resin castings and turning blanks. This type of resin will allow the light to pass through, causing the glitter to sparkle.

Prepare the objects you want to embed before mixing your epoxy resin. This will hold your item in place, keeping it from falling over when you have completely poured all your resin. Wait about 15 minutes then use a new toothpick to move around the resin and glitter in the mold to fill in any.