Push the beads over the hook part and they will thread onto the hair.

Step by step how to put beads in hair. Pass this through the bead; Tip question comment step 4: Grab a hank of hair with your left hand, slide the loop of string off.

Get a thread and make a loop; Take the needle and push the beads back so they start where the thread comes up from the fabric. Wrap the loose ends of the string around a finger or two on your right hand to hold them.

Add the desired number of beads onto the bobby pin. You will need hair beader, beads of your choice, rubber bands, and hair (of course! Pull your braid through your beads by pulling on the beader tool.

You can stick the pin into the hole in the stick to test the effect, compare one. Take half an inch of hair and feed. Add the dome by placing clear glue around the edges and press it in place.

Add the beads for the beaded part, take a headpin, cut it a bit before the end, add a. Wash and dry your beard; Put the end of your braid through the bobby pin.

Use the following steps to put beads on with a bobby pin: Making the beaded top when your finish is dry to the touch, take a pin, and arrange your beads on the pin. Load the beads on the beader in the pattern that you would like.