Splicing wires without using butt splice connectors.

Splicing wires without solder. A soldering iron and solder. Rotate the cap clockwise for approximately five seconds. Fan out the remaining copper strands on each wire.

For a splice between two copper wires or tinned copper wires google western union splice these are robust even under tension and make a good joint without solder. Be sure to strip enough insulation from the wire. It also keeps the strands together.

The best way to splice wires is to wrap them together tightly, using multiple twists to ensure maximum contact between the two wire sections. Use the soldering iron and. Slip the heat shrink tubes beyond the wires’ ends so they don’t tighten while soldering.

The wires should coil themselves inside of. Something to splice 1 thumb and 1 finger per hand hemostats or needle nose pliers and maybe some gloves (see below) wire stripping utensil solder soldering iron insulating material (heat. Makes it easier to easily solder wires together in tight areas.

If you are lucky enough to have some type of butt splice connector on your wires, soldering the wire together will produce. How to solder wire without a soldering iron source of heat. It is better to solder but this method works great and is.

Apply a drop of flux on the wire. Plug or turn on the soldering iron to heat it to around 752 degrees fahrenheit, which should take a minute or two. The best method showing how to easily solder wires together with no soldering iron!