To do this, set the wire cap on top of the exposed wires and start twisting.

Splice wires without solder. Pre tinning the wires makes it easier to solder the joint together. Plug or turn on the soldering iron to heat it to around 752 degrees fahrenheit, which should take a minute or two. Twist the ends of the strands together to form an ‘x’ pattern.

Ensure the tip is securely attached to the iron. The most common technique in residential wiring is to use a splice that winds the wires together. Loop the remaining copper around the other at least 3 times.

If you are lucky enough to have some type of butt splice connector on your wires, soldering the wire together will produce. Apply heat shrink to one of the wires. Rotate the cap clockwise for approximately five seconds.

Just simple way how to join 2 wires.sub for more or check my channel,i have hundreds of diy videos,thanks Ensure that approximately an inch of metal wire is exposed on each wire. Something to splice 1 thumb and 1 finger per hand hemostats or needle nose pliers and maybe some gloves (see below) wire stripping utensil solder soldering iron insulating material (heat.

Make sure to choose a heat shrink tube that is thin enough to fit tightly over your wires upon heating. Use the soldering iron and. A plastic connector, called a wire nut, is used to insulate and secure the splice.

It also keeps the strands together. To solder these wires together, you will have to heat the. The best way to splice wires is to wrap them together tightly, using multiple twists to ensure maximum contact between the two wire sections.