Gas leaks will reduce the amount of gas reaching the burner.

Rheem gas water heater pilot light. While keeping the control knob down, press the ignitor button 10 times with your. Water heaters, like all appliances, need regular maintenance. I followed the instructions, turning the knob to off, waited 5 minutes, turned knob to pilot, depressed the knob, and pushed the ignition button multiple times the light then began.

Check if the wire connection is tightened correctly. If your label is yellow: If your label is yellow:

Once the pilot is lit, you’ll see it. Choose a gas hot water system: This is a complete guide on rheem water heater blinking light codes.

The dirty gas chamber is the main culprit that causes your rheem water heater to not light the pilot light. Turn the gas off to the water heater and press the piezo igniter. Push in the knob and hold it in.

Improper thermopile connection to the combustion gas chamber. Besides, igniter wires issues and a faulty. As you have read above, the rheem water heater’s red light flashing 2 times every 3 seconds means there.

Straighten all kinks on the flex tube. Check the lighting instruction label inside the front of your water heater. It’s also wise to look for any visible damage that might cause gas leaks.